G
geoph1986
Just like the title says, I need some pictures for reference. Long story short, due to LIM repair by the previous owner, I needed to replace and reroute a bunch of vacuum stuff. While doing so I have noticed that the wiring harnesses aren't routed or fastened properly. They are all connected to each other properly, but they're just hanging around. I don't need to know where anything connects, just need to see where the harnesses are supposed to run.
So I can route and fasten these in their factory locations, I would very much appreciate it, if someone would post a decent picture of the following areas of the engine compartment:
1: Engine, driver side
2: Fender, Driver side
Thanks in advance,
Geoph
So I can route and fasten these in their factory locations, I would very much appreciate it, if someone would post a decent picture of the following areas of the engine compartment:
1: Engine, driver side
2: Fender, Driver side
Thanks in advance,
Geoph