Lund Hardware Question

[MAS Tequila]

My rear Lund visor got knocked of going down the highway a few months ago.

I found one.

My question is what type of hardware ware did they use to attach these?

Any help will be appreciated.

 

[DemonMudder]

I'm not 100% on the rear one, but I recently ordered the front Lund moonvisor and it's full set of equipment on Ebay. Altogether it was about $300 but I saw some of the equipment such as the screws at like $10. So my suggestion, try searching ebay or other used sites. I'll take a look as well and let ya know.

 

[DemonMudder]

You're talking about a lund windjammer, right? Sits right above the rear windshield, spoiler looking thingamajig? If that's it, I've seen that most people tend to skip the screws and attach with 3M tape instead. So, you could always try that, unless you had it screwed in before that is. I mean my moonvisor screws are done with a 15/64" (slightly smaller than 1/4") drill bit, these are its screws: MOUNTING HARDWARE KIT FOR LUND SUN VISOR, BOLTS & CAPS MOON VISOR HARDWARE | eBay
I'm not sure if they're the same but, I figure it's worth a look