Need Remote Start Help

[Scott2008]

I was wondering how to tackle the following:

I install an alarm/rem start. It all works fine except:

After arming the car (locking the doors) aafter about 10 min or so, if I go to unlock the door with the transmitter, it sets off the factory alarm. I have to get in the car and turn the key to the on position. If I remote start the car before I unlock the door, there is now issue (as if I applied ign prior to unlock).

Is there a way around this or a way to disable the factory alarm system?

Thanks much!

 

[Scott2008]

2002 4.6 eddie baur

 

[DMacLennan14]

did you put a factory alarm bypass module in there? if so, it probably isnt programmed correctly. if you didnt put one in, you have to have that for it to work correctly.

 

[kelly2]

you posted this one the12volt too? sounds just like a question that was asked over there. exact same vehicle too. did you read our responses yet?

http://www.the12volt.com/installbay/forum_posts.asp~TID~99855~PN~1

 

[Scott2008]

you posted this one the12volt too? sounds just like a question that was asked over there. exact same vehicle too. did you read our responses yet?

http://www.the12volt.com/installbay/forum_posts.asp~TID~99855~PN~1

Yes, I did post there and am now trying to find the factory disarm wire... thanks for the help!!!

 

[Scott2008]

This post above is accurate. The middle plug on the security module (green) has 16 wires. The grn/purp pin #5 is the factory disarm wire neg input. It's required to deactivate when installing an aftermarket keyless. I did not have to use it for the remote start when using the pats integration module.

 

[kelly2]

a belated update? glad to see you got it worked out

 

[Scott2008]

Yes, it is delayed. I actually was procrastinating a bit cause I didn;t want to pull the dash and search in the kick and all. Finally, I got a new woofer and am going to do a custom build were the factory sub is located. Long story short, there was the factory module, so I ran a wire from the rem start brain to that wire and "presto" alls good in the work of remote start/alarm!

Better late than never I guess