hey man
Dont know if you've gotten the front driveshaft off yet, or not?
If not, then here is what you need to do to take it off:
There is a small T-case skidplate that has two bolts on eavh side. I dont remmber what size they are but, you can find that out. Take those four bolts off and drop the plate. There will also be 4 nuts sitting inside of the "C" shaped frame. They arent welded on but they do have a square on them, so that, they dont spin when tightening or loosening them.
After you get that off you need a Loong screwdriver and a X sized wrench. ( i dont remmber that one other).
You just need to mess around with sticking the screwdriver through the CV joint, so that, it will wedge up agasint something. Then take your wrench and remove the 2 + 2 =4 bolts that are holding on the Ujoints. Each end of the u-joint has a strap over it which is held down with a bolt on each side.
Just do that to the front of the drivesahft and the rear.
Bolt the skidplate back on and you are set. You might need a helping hand to hold the skidplate up while you get the first couple of bolts going.
Hope that helps out man,
Kendal
