bkb88
Member
- Joined
- April 22, 2010
- Messages
- 36
- Reaction score
- 0
- Year, Model & Trim Level
- 94' Eddie Bauer
I recently had my front passenger side wheel bearings go out and I had to end up cutting the inner bearing race off of the spindle. I noticed that the abs wheel sensor looked like it had came into contact with something but just cleaned the sensor up and went on with installing my new rotor/bearings. Well, after I tightened the spindle nuts for my manual hub conversion to the correct torque I found that my rotor has a slight wobble and only rotates about 1/4 of a turn then hits the abs sensor. Any ideas on what could cause this? Possibly my spindle is screwed up?