-
Ford Explorer Community - Maintenance - Modifications - Performance Upgrades - Problem Solving - Off-Road - Street
Explorer Forum Covers the Explorer ST, Explorer Sport, Explorer Sport Trac, Lincoln Aviator,
Mercury Mountaineer, Mazda Navajo, Ford Ranger, Mazda Pickups, and the Ford Aerostar
Register Today It's free!
test tps sensor on 01 ford ranger with 3.0
- Thread starter glackey88
- Start date
Jstcruz
Well-Known Member
- Joined
- July 24, 2010
- Messages
- 786
- Reaction score
- 5
- City, State
- Deltona, FL
- Year, Model & Trim Level
- 97 Ex XLT & 84 Ranger
glackey88
New Member
- Joined
- October 8, 2012
- Messages
- 2
- Reaction score
- 0
- Year, Model & Trim Level
- 01ranger
jst cruz,keep getting codes 1132 and 1152 running rich in upstream according to all scanners hooked up.i replaced all 3 02 sensors,dpfe sensor,fuel filter,egr valve,vacuum lines,cleaned throttle bady and idle air control valve.keep resetting computer and it keeps throwing cel on and reads same codes still.truck rund smooth no smoke or acting funny.checked voltage at tps sensor and its within specs.dont know what else to do and this truck is getting me frustrated.any ideas would be great
Jstcruz
Well-Known Member
- Joined
- July 24, 2010
- Messages
- 786
- Reaction score
- 5
- City, State
- Deltona, FL
- Year, Model & Trim Level
- 97 Ex XLT & 84 Ranger
I had a cel I couldnt figure out for a long time on my EX, it was showing a lean condition. So I replaced everything you did and nothing. We just replaced all the gaskets in the upper intake and it fixed everything. this may not be your issue but its something to look into. I would wait and see what someone else has to say.
Explorer Features
Explorer Features
