Trans Problem 1992 Ranger 4x4

[Maniak]

The rooster comb, and shift linkage were the only two easy things.. Since its not those, its an internal issue, which means rebuild.

~Mark

 

[Toddexplore]

Anyone know where I can buy a 1988-1992 Ford Ranger / Bronco in Edmonton Alberta Canada?

 

[Toddexplore]

low/reverse servo

Might this be a the problem? Where is this thing? I have the pan off but will need some help.

 

[Toddexplore]

low/reverse servo

Might it be this? I have the pan off..?

Also what other trans bolt right in.. 1988 Bronco? Explore? rangers? 1988-1993?? Maybe

 

[BrooklynBay]

The low/reverse servo is the part which is located behind the 4 bolt cover underneath the transmission.

 

[Toddexplore]

Anyone have a picture?

Do you think this might be a problem? I have no Rev.

 

[BrooklynBay]

This part controls manual 1st as well, so if you don't have reverse, you won't have 1st either. Pictures could be found here.

 

[Toddexplore]

oh ...Strange..

I think my N is F&(*9 too..It is like everything has slipped forward...Strange..
What other truck use this trans?

 

[Toddexplore]

What are the two TCC Solenoid in the trans for? One of the caps seem loose?

 

[BrooklynBay]

You only have one TCC solenoid.

 

[Maniak]

I'm assuming a4ld transmission here... One solenoid is for the TCC (torque converter control) and the other is for the 3/4 shift.

~Mark

 

[Glacier991]

And the end "cap" can seem loose on a perfectly good one.

 

[Toddexplore]

Do you think it would be worth changing out the low/reverse servo ?

 

[BrooklynBay]

Check to see if it's chipped. If not, then just replace the 2 seals. You have 3 choices. You could use regular O rings (OK), the double lip seal (better), or the viton D ring kit (best).

 

[Toddexplore]

Does anyone know the dia. of the ring? A Trans shop has bulk and I don't have the old one for him to compare the new..He should just be able to compare by the dia or sizes of the circle?

 

[BrooklynBay]

WWW.TransmissionPartsUSA.Com has them: http://www.transmissionpartsusa.com/A4LD_4R44E_5R55E_reverse_servo_D_ring_kit_p/230-00023256k.htm

 

[Toddexplore]

Soooo I took it off the cap of the servo but forgot to mark the cap...Is there anyway to figure out which way it goes back? I guess it has a higher point and lower point..

 

[BrooklynBay]

There are 2 seals. One is larger than the other.

 

[Toddexplore]

Does the cap go back on easy or does it need a tool? Seems easy...

Is there a special way it needs to go back together?

 

[Glacier991]

It will only go on one way, the holes are not symmetrical, and it is not hard to put on so going on 'easy" is normal.