makaveli923
New Member
- Joined
- September 16, 2010
- Messages
- 7
- Reaction score
- 0
- City, State
- Stoney creek
- Year, Model & Trim Level
- 99 xlt
I just put a new engine and transmission in my friends 99 explorer its a 4.0l sohc. Before i did this the gear selecter when you were in park it was to the right almost in the middle of park and reverse and new it wont crank in park because the needle is too far over but when i put it into neutral it will crank but it doesn't show neutral because its off by a nice bit. would it do this because technically its not noticing it in park it thinks its in reverse. How would i adjust the needle on the dash.