ryan8795
Member
- Joined
- January 29, 2015
- Messages
- 21
- Reaction score
- 0
- City, State
- Revelstoke
- Year, Model & Trim Level
- Ford Explorer
Hi,
So I had a wheel bearing replaced (I think the ABS sensor was disconnected to get it on a joist) and when I got the car back the Advtrac light flashes on start up, then eventually an error pops up saying 'check advtrac', then the light is on constantly.
The error code from the diagnostic was C-1998-0E ABS with a 'Calibration module failure' message.
Does anyone know what this means, or how to clear it?
So I had a wheel bearing replaced (I think the ABS sensor was disconnected to get it on a joist) and when I got the car back the Advtrac light flashes on start up, then eventually an error pops up saying 'check advtrac', then the light is on constantly.
The error code from the diagnostic was C-1998-0E ABS with a 'Calibration module failure' message.
Does anyone know what this means, or how to clear it?