Im gettin ready to lift the body off mine. Just double checking how many body bolts holding it? 2 rad support, 2 front floor board, 2 behind front seats, and 2 by the hatch. And from what I read but forgot to take out there are two under the rear seats?
10 total body mounts. 4 in the rear deck, 4 in the seating area, 2 up front.
There is other things to "Prep" before lifting and the instructions are somewhat fuzzy on what all to do.
Very important things to do ahead of time are:
Soak with PB Blaster or similar product prior to removing body mounts.
Use a long breaker bar to break free then use an impact wrench if possible to finish the removal.
Remove one side completely, and back the other side out to where there are just a few threads left in the mounts before jacking the body up.
Remove the transfer case harness at the case and disconnect.
Disconnect the E-brake cable under the dr door, and run it OVER the body mount and leave loose for now.
Remove the trans cooler lines from the clips under the radiator core support.
Remove the brake line support bracket on the front of the master cylinder.
Remove the ground strap,and all wire harness that dont have slack, on the firewall.
Remove the vac line on the purge canister.
Remove the fan shroud, leave loose and rest on the fan/engine.
Remove the steering shaft coupler (install the extension on the upper shaft if your doing a 3" lift).
Here is a thread to help on the front body mounts.
http://www.explorerforum.com/forums/showthread.php?t=284834
