2000 ford explorer power windows help please

[Timmy2012]

The blue and white wire fell out the connecter i need to know which hole to put it in please any help would be greatly appreciated

 

[Timmy2012]

The pins are numbered on the back of the connecter just not sure what hole it runs too

 

[JDFBear]

this might help good luck

 

[Timmy2012]

Wow thank you so much been 3 days looking for answers do u know if i just slide it back up in there or if i need aome sort of connecter

 

[Timmy2012]

this might help good luck

View attachment 329107

View attachment 329108

• #4

Wow thank you so much been 3 days looking for answers do u know if i just slide it back up in there or if i need some sort of connecter

 

[JDFBear]

You should replace the pin but not sure where you can get one other than the bone yard. You can download the factory service manual it’s somewhere on this site. Has all the diagrams

 

[EB4X]

Maybe one of these female ones will work after removing outer insulation:

50Pcs Heat Shrink Bullet Female Male Wire 10-22WAG Connector Crimp Terminal Kit | eBay

10Pcs Yellow Connectors: Suits cable / wire sizes 12-10AWG / 4.0-6.0mm² (5 male, 5 female). - 20Pcs Blue Connectors: Suits cable / wire sizes 16-14AWG / 1.5-2.5mm² (10 male, 10 female). - 20Pcs Red Connectors: Suits cable / wire sizes 22-16AWG / 0.5-1.5mm² (10 male, 10 female).

www.ebay.com

 

[J_C]

• #4

Wow thank you so much been 3 days looking for answers do u know if i just slide it back up in there or if i need some sort of connecter

I've not had to deal with this, so being sort of vague here... pull the insert out and see what's going on, if there is the rest of that wire in it and and frayed in two, you may be able to use a punch to drive that portion of the wire out of the existing contact, or a chisel to open it up, then slide the trued up end of the wire into it and crimp it tight, or solder it in.

I mean "most" Ford connectors have a way to put the contact out and service it, if you have the mindset of doing so.