Search results

I've checked the other threads and all of the guys with similar problems seem to have body lifts. My 1994 X is stock height and the steering is getting squirrelly. The steering wheel is also ****ed a little to the left when the X is going straight. I've checked the tie rods and they're...

I've been reading the posts about the indiglo gauges and people putting on aftermarket gauges for tranny temp, etc. I came up with some questions about swapping analog gauges for a digital cluster, from say a lincoln or an aerostar. - Is this even possible? - Would you need new sensors for...

I hope that this belongs in the 911 thread, as I'm running out of options. I need ammo when I take my Ex back into the shop tomorrow. It's a 1994 XLT 4wd with 118,000 miles on it. I got the slave cylinder and master cylinder done on Mon. (I kept having to add fluid and finally couldnt get it...

Well, happy holidays to everyone. Mine isn't so happy as it would seem that my slave cylinder has gone out again and I need to know what to get replaced, etc. Currently I have a 1994 XLT 4x4 with approx. 117K miles on it. At about 90K I had the clutch and all of the other goodies like the...

I recently got the wonderful check engine light on my 94 XLT to come on. I pulled the codes from it and got the following: KOEO 335 PFE or DPFE sensor out of self-test volt range 522 Not in park or neutral during test (not really important :) ) CM 332 EGR valve not opening not...

Hey all, I have a 1994 XLT, 4.0 ohv, 5spd, 111K mi on it. I recently crawled under it to change the t-case fluid, and saw that the tranny had some fluid coating it where it met up to the engine. So, I checked the fluid level in the tranny, because I read about the rubber plugs that go bad...

Ok, I've looked for the answer to this and can't find it: I know that series wiring will raise the impedance, while parallel setups will drop it. Drop it too low, and your amp/headunit will not work. What happens is you raise the impedance? It draws more amps doesn't it? Will this be bad for...

Well, I didn't find an answer to this anywhere, so I decided to ask. My plan is to do what SilverSportTrac did in his post about LED's and get some bulk LED's, some resistors, and a breadboard from radioshack to replace my dome light. Using a calculator online I know what type of resistors I...

I have a 1994 XLT. I've been trying to find out my gear ratio and paint color. Yes, I know, look at the sticker on the door jam, but I dont have one! Is there any site, person, or place that can tell me this info if that all important sticker is missing? Any help would be appreciated.