the | Page 7 | Ford Explorer Forums - Serious Explorations

  • Register Today It's free!

the

  1. 1995 Mass Air Flow (MAF) with the block off plate removed.

    1995 Mass Air Flow (MAF) with the block off plate removed.

  2. TSB 92-5-12 Case spring in the converter channel of an A4LD transmission.

    TSB 92-5-12 Case spring in the converter channel of an A4LD transmission.

    A spring was installed in the transmission case worm trail to trap large machining chips, and reduce engine stall complaints caused by the stuck converter lock-up valve in the main control of the transmission. This spring should not be installed in transmissions built prior to 8/21/91.
  3. This ring holds the blade guard in place.

    This ring holds the blade guard in place.

  4. The switch is good, but the battery contacts are not.

    The switch is good, but the battery contacts are not.

  5. The spring with the blade guard removed.

    The spring with the blade guard removed.

  6. The spring of the blade guard.

    The spring of the blade guard.

  7. The motor with the mounting base plate.

    The motor with the mounting base plate.

    This is the motor from a Craftsman cordless trim saw.
  8. The motor is removed from the 14.4 volt cordless trim saw.

    The motor is removed from the 14.4 volt cordless trim saw.

  9. The motor is installed, and the saw is ready to be closed up.

    The motor is installed, and the saw is ready to be closed up.

  10. The motor is connected with 4 screws.

    The motor is connected with 4 screws.

  11. The 14.4 volt cordless trim saw is dismantled for spare parts.

    The 14.4 volt cordless trim saw is dismantled for spare parts.

  12. Removing the rear cover.

    Removing the rear cover.

  13. Comparison of the upper blade guard.

    Comparison of the upper blade guard.

    This is for a cordless trim saw.
  14. Comparison of the lower base plate.

    Comparison of the lower base plate.

    This is for a cordless trim saw.
  15. Comparison of the inside of both saws.

    Comparison of the inside of both saws.

  16. Close up of the motor.

    Close up of the motor.

    This is the electric motor inside of a cordless trim saw.
  17. The upper holes are drilled.

    The upper holes are drilled.

  18. The rear view of the combination lock.

    The rear view of the combination lock.

    This is what the rear of the keyless entry lock looks like on the back of the door.
  19. The lock is installed!

    The lock is installed!

  20. This is how you break off the shaft.

    This is how you break off the shaft.

  21. The steel door comes with two holes.

    The steel door comes with two holes.

  22. The side of the door with the latch.

    The side of the door with the latch.

  23. The rear shafts need to be cut to the width of the door.

    The rear shafts need to be cut to the width of the door.

  24. The lock is installed!

    The lock is installed!

  25. The door needs another set of holes.

    The door needs another set of holes.

Back
Top