03 Exploder XLS 4X4. Doing A1JE servo repair. Had a broken intermediate servo shaft, which wound up getting pushed through the bore and ending up on top of the band (it has been removed). With the servo removed, then the valve body, I discovered the intermediate band strut was gone. Not in the pan, nowhere to be found. I am able to rotate the band 360 degrees, so I assume the servo side strut has become dislodged. The band does not appear to be broken. I know the adjustment side band strut can be replaced without dropping the trans. My question and dilemma: What about the servo side strut? Also, I cannot get the overdrive servo cover off. It does move a little when compressed, but will not pop out far enough to get any type of tool to grab it. Any advice or help on the initial issue would be greatly appreciated. Trying my best not having to drop the tranny. Truck in really good shape, 155000 miles, except the tranny.