3D Printed Parts

[BluIsBlue]

Has anyone made any 3D printed parts for the interior or exterior of the 2nd gen? Seems hard to come by anything.

I’m specifically looking for the cup holder insert for the large cup holder in the center console.

This thread is open for you to post potential ideas for parts and links/pictures/stl files for your own homemade parts!

 

[BrooklynBay]

Did you check WWW.Thingiverse.Com?

 

[BluIsBlue]

Did you check WWW.Thingiverse.Com?

I did! There’s very little that is made for second gens on there :/

 

[BrooklynBay]

Is the insert just a liner for an existing cup holder? Check the measurement with a digital caliper. The 3D drawing program is set to use milimeters.

 

[Fix4Dirt]

Whats the part you want made? Send a picture of it. I think I know what youre talking about but want to confirm. If so I can maybe make a file to send to ya. If Im thibking of it correctly I could extrude a circle to make a cylinder then use hole wizard and make a hole almost to the bottom but not all the way.

 

[Fix4Dirt]

I have 3d printed door striker bushinngs. Made em out of polycarb. Should be on Thingiverse.

If other folks have stuff they want printed let me know I can make files when I have a chance

 

[BrooklynBay]

TPU would be good for the insert to prevent it from slipping. Hot melt glue or double sided tape goes in first on the bottom then the insert goes on top of it. 2 MM to 2.5 MM is good for the wall thickness with a solid infill.