As most of you know I just did a 302 swap into my 92. Now, the C6 that i had in the truck was junk, so I got a 4 speed. Has anyone ever stuck a 4 speed manual in an explorer? Is there anything I need to do majorly to make it fit into the truck? My only major concern is the placement of the shifter, and where it is going to come through the floor. Im hoping that it is in the correct spot on the explorers floor, and not under the dash, cause then I will need to redo my motor mounts and move the motor back farther, and possibly cut the firewall.
Does anyone know if the manual T-case from my c6 will work on the 4 speed? My 4 speed tranny doesnt have a tail shaft on it right now, does anyone now if the tailshaft from my c6 will work on the 4 speed. BTW the 4 speed is out of an 85 F150 with a 302.
Thanks in advance.
Andy
Does anyone know if the manual T-case from my c6 will work on the 4 speed? My 4 speed tranny doesnt have a tail shaft on it right now, does anyone now if the tailshaft from my c6 will work on the 4 speed. BTW the 4 speed is out of an 85 F150 with a 302.
Thanks in advance.
Andy