A4ld shifter help

[Fordexplorerguy1]

The shifter in my a4ld doesnt line up after rebuild you can see in this pic:

0413011247.jpg by Justinsdiy, on Flickr


its supposed to be in park but the shifter in the pan isnt on the teeth like its too far. My question is can you adjust this so it will line up where its supposed to???

 

[ragga]

I can't tell where your manual valve is lining up... If you put shifter in 2, the first land on the manual valve should be flush with the edge of the bore, on the z clip side....supposed to be within about .01 inch of flush. If not you can adjust it to correct position.

Respects,
Ragga

 

[Fordexplorerguy1]

if you look at the photo the pickle fork is off of the little gear looking part of the shifter,like its too far. i think i did this when i was going to replace the seal for the shifter but decided not too... At least i have my problem pin pointed