KRAM1
Active Member
- Joined
- March 31, 2006
- Messages
- 77
- Reaction score
- 0
- City, State
- North Wales,PA
- Year, Model & Trim Level
- '05 XLT
Nov 20, 4pm. I decided to have a sub + amp installed at a local electronic shop. It was close to midnight and it's not done yet
Well, the sub and amp are in place but my vehicle went into fail safe mode..rough idle, dies down went accelerator is depressed etc.. the service engine light, a tool sign ( an open wrench), and adv-trac light came on. The service engine light went off after the battery terminals were disconnected and reconnected back but the other two lights are still on. Somehow there were wires near the firewall that were scraped off. Problem was not solved even after the wires were taped.
The next day my vehicle was towed to the delearship and the problem was explained to the senior tech. I'm not sure if much work has been done considering the upcoming big holiday..I did call the next day to check on the status and was told it should be ready by Saturday...saturday came nothing happens. I called this morning and was told that my processor was fried:thumbdwn: ..parts should come in shortly and my vehicle should be ready, hopefully, in 4 days.
Did anyone experience this before?

The next day my vehicle was towed to the delearship and the problem was explained to the senior tech. I'm not sure if much work has been done considering the upcoming big holiday..I did call the next day to check on the status and was told it should be ready by Saturday...saturday came nothing happens. I called this morning and was told that my processor was fried:thumbdwn: ..parts should come in shortly and my vehicle should be ready, hopefully, in 4 days.
Did anyone experience this before?