For everyone that has done the TT please help me out here..

[WannaXP8]

I just did the TT on my 98, and my problem lies in, that I was lowered and I dont know where the stock hight was..so I cant measure from the ground to the fender to see if Im up 2 inches..so can all of you that has done the lift, can you measure yours for me and Ill compare it to mine..just take a tape measure and measure from the ground to the fender lip..like right in the middle..thanks

 

[Jason_25]

That technique would only work if the person measuring had the same size tire as you.

 

[WannaXP8]

oh..thats a good point..well if you have 31s..im running the stock size tire right now..so Ill like subtract like a inch or so..wouldnt that work?

 

[addkev]

Is it AWD? I am thinking it is since you are worried about the height. You can always lift it and just listen for your CV's clicking to know you are too high. I raised mine about 1-3/4" and had to back it down just a bit because of the pass. side CV.

Good Luck. Kevin

 

[WannaXP8]

How loud is the clicking? Yes its a AWD.

 

[addkev]

It is not loud, but w/ the windows down you can definitely tell it is clicking and from which wheel it is coming from. Just crawl under and lower it a turn and drive around the block to check it again.

 

[rickfireftr]

Stock Height

I am not sure this will help but my '00 xls started at 32 7/8 and 32 5/8 in the front with P235/75R15 and went up about 1 7/8. See my post on torsion 101

 

[Stic-o]

hhhmmmmm.....

mine started out at 32 3/4 and now is at 34 3/4 or 35. No cliking though, however at 65 and higher it vibrates kinda bad and also if i take off full throttle unil i get to 35. I think it's just alignment though(or so i hope). I also belive this because after 300 miles you can already start seeing ware on the outside edge of the front tires

 

[Ray Lobato]

Look at the CV angles. At stock height, your CV's should be parallel to the ground, or straight.