need help asap truck will not move

[Maniak]

Because the proper way to do it is to grind down a couple teeth on the ring gear instead of grinding down the cross pin.

~Mark

 

[91exploreron37]

Yea we did both the first time my 5.13s were installed but the second time I went ahead and bought the modified cross shaft.
So the ground down stock cross shaft was the one that was installed in the locker?

 

[sajnaj]

the shaft that was ground down was in the locker i am going to wait for a new locker to arrive and put the notched shaft in.

 

[91exploreron37]

I thought you werent supposed to run a notched cross shaft with a locker?

Also are you 100% sure thats the problem?

 

[sajnaj]

got some more pics the locker does not have that much damage just a lot of chipping on the teeth it was hard to get some good pics but got a couple. now i just have to hope that Aussie will warranty the locker and re assemble and hope for the best.

 

[kert0307]

I still don't understand how the locker can be blamed for the truck not being able to move under it's own power. If the locker was not working properly, i would think it would drive like it had a spool, or only engage one wheel in slipping conditions. Have you tried shifting into gears with no drive shafts attached?