Need Pic

[zhanx]

Manual Transmission Clutch Resivor location. I am currently prepping my truck to install joshc's manual transmission i bough from him. Everything is going good but i need a pic of where it goes trying to make it look as stock as possible. I know I know i should just install it where it fits but thats the way i am.

 

[Mud Bug 94]

i know its next to the brake master cylinder i beleive on the right towards the fender.

 

[JoshC]

You can put it anywhere you want to on the firewall, there's no specific location that is has to, all it takes is a screw to hold it. I put it on the DS fender right beside the distribution box.

If you didn't notice, i still owe you the flywheel! I can't seem to get mine off until i get another hand to hold the crank. Air gun would only get one bolt off.

I do need a piece from you too!!! Tucked up under the dash by the petals over toward the left hand side is a wiring harness. It plugs into the master clyinder i'm wanting to say. Anyways, on that wiring harness is a cap per say that has some jumpers in it. It allows the stock auto equipped explorer to start, but it's not used when you put the manual in. I need that part! Let me know if you need help finding it.

EDIT: i just saw where you said you were trying to keep it stock...i don't know where the stock location is.

 

[FireZapper]

It's located on the cowl access panel on the drivers side.

 

[zhanx]

You can put it anywhere you want to on the firewall, there's no specific location that is has to, all it takes is a screw to hold it. I put it on the DS fender right beside the distribution box.

If you didn't notice, i still owe you the flywheel! I can't seem to get mine off until i get another hand to hold the crank. Air gun would only get one bolt off.

I do need a piece from you too!!! Tucked up under the dash by the petals over toward the left hand side is a wiring harness. It plugs into the master clyinder i'm wanting to say. Anyways, on that wiring harness is a cap per say that has some jumpers in it. It allows the stock auto equipped explorer to start, but it's not used when you put the manual in. I need that part! Let me know if you need help finding it.

EDIT: i just saw where you said you were trying to keep it stock...i don't know where the stock location is.

i got it will mail it out asap for ya. need to know what shipping cost also.

 

[zhanx]

It's located on the cowl access panel on the drivers side.

tell me you gots a pic cause i stared at it and said well he said it goes there, but where is there????

 

[FireZapper]

Sorry for the delay.

 

[zhanx]

thanks for the pic. there isn't room there because of the power junction box. so i had to put it on the fender between the junction box and the abs