need quick answer....about swaybar end links.

[EliteConcept]

heres the deal, i recently replaced the swaybar end links and the clunk i was having went away...but it came back about 2 weeks later, i think they may be the problem again for some reason. anways i want to check, is it possible to remove the sway bar end links and drive just around my block to see if my clunk goes away with them removed?

thanks
ryan

 

[Alec]

Yes, this is how we disco our bars for wheeling. Front or rear? If it's the rear, just be careful as repeated loosening and tightening of the stock bolts-through-the-bushings can cause bushing failure.

 

[EliteConcept]

no up in the front,
could i do only one side? or would that cause a problem?

i'm also looking in to greasing the slip yoke,

 

[X~FACTOR]

Unbolting the endlinks shouldn't cause any problem both front and back. Unbolting one side only might put too much stress on the bushings that is connected to the frame though. Just unbolt both sides and you should be fine.