eazyasone23
Active Member
- Joined
- September 22, 2010
- Messages
- 95
- Reaction score
- 0
- City, State
- Effort, PA
- Year, Model & Trim Level
- 99 XLT
Ok i was looking at the truck a couple weeks ago after i did TT and a new shackle install. The rear is perfectly level but i noticed my driver side dipped a little well almost 1.5 inches. So i went back out and twisted the torsion bolts again but only on the driver side. The driver side is totally maxed out yet the pass side bolt still has more than half the screw left. Is this normal? I figured I might need new torsion bars? Maybe new springs up front? Thanks
