robmurt04
Well-Known Member
- Joined
- December 23, 2006
- Messages
- 369
- Reaction score
- 0
- City, State
- Pennsylvania
- Year, Model & Trim Level
- '94 4WD
Do you need to notch the cross pin shaft when using a Lockrite Power Trax to replace to spider gears (I'm installing 4.56:1 Yukons)
If so, I read that you can grind a little bit off the teeth of the pinion for it to work? Is there a write up on this anywhere? Thanks
If so, I read that you can grind a little bit off the teeth of the pinion for it to work? Is there a write up on this anywhere? Thanks