Question for those with aftermarket fiberglass fenders

[ProjectAviator]

I am looking to possibly get a pair for my 95 XLT. I am wondering if any thing is modified under the hood. on the inner fenders?

Tim

 

[410Fortune]

inner fenders usually get removed or chopped up
With all this snow and slush in CO though its a good idea to make some new liners to protect your engine bay and door pockets from all that crud

I made some out a big sheet of ABS plastic, total cost was about $30

They are not mounted currently because I need to remove my fenders to finish the job, I plan to fiberglass in a mounting tab about every 6" so they dont flap in the wind, I tried epoxy and it wouldnt work haha I need to be able to remove them quickly so I want to do it right

You may have to re-route some wires and protect your air filter, I made a couple of simple shields to protect my lights and air filter until I finish the full liners. Any exposed wires you will want to wrap with plastic conduit, etc

Its nice having custom liners because I am able to allow alot of heat out of the engine bay (headers)
With the fiberglass fenders the new wheel opening is huge, so factory fender liners look like as*