After replacing the door latch and actuator on my 94 Explorer, see http://www.explorerforum.com/forums//showthread.php?t=170619 ,
it was time to re-install of the door panel. After putting the plastic water shield back on with double sided tape and replacing a few plastic panel "rivets" I set the panel back on the door. After aligning everything and getting everything to work I am now stuck on how to get the two two inch screws that hold the panel to the door just above the door pull on the inner panel lined up well enough to screw them in. Just can't seem to line them up. Have thought of using two lengths of stiff wire about eight inches long (coat hanger?) to run out from the clips through the door panel and line them up that way. Any other ideas?
it was time to re-install of the door panel. After putting the plastic water shield back on with double sided tape and replacing a few plastic panel "rivets" I set the panel back on the door. After aligning everything and getting everything to work I am now stuck on how to get the two two inch screws that hold the panel to the door just above the door pull on the inner panel lined up well enough to screw them in. Just can't seem to line them up. Have thought of using two lengths of stiff wire about eight inches long (coat hanger?) to run out from the clips through the door panel and line them up that way. Any other ideas?