Removing doors.

[Drednaut]

So in early november i got in an accedent with my 92 eddie bauer 4x4 and the way i was hit i would need to use a frame meachen to fit new doors on to it so ive decided to remove all the doors and was wondering if anyone knows where i can get door nets or something to that matter. or if anyone else has done the same what was your solution?

 

[Drednaut]

Anything? Anybody?

 

[Flip4ford]

WOW you waited a whole 2 hours at 2:00 in the morning before you posted a bump--

you might need to learn a little paitence- and do a search for doors.

Most people I have seem make their own 1/2 doors, out of tubing and door skins from a jyard. a net across a whole door with no support would not be a good idea.

 

[little x]

I don't use any net or 1/2 doors. Just wear your seat belt and don't leave loose objects on the floor.

 

[Drednaut]

WOW you waited a whole 2 hours at 2:00 in the morning before you posted a bump--

you might need to learn a little paitence- and do a search for doors.

Most people I have seem make their own 1/2 doors, out of tubing and door skins from a jyard. a net across a whole door with no support would not be a good idea.

yeah i was thinking about the tube stock to make half doors but idk yet i still gotta a few monthes before i can work on it

 

[section525]

Everything will have to be custom. There's a chance you'll find some used tube doors that someone else built though.

But you plan on driving that thing again??

 

[Drednaut]

Everything will have to be custom. There's a chance you'll find some used tube doors that someone else built though.

But you plan on driving that thing again??

yeah ive driven it since then and it runs and drives fine, just after i got the drivers side doors open i couldnt close them again , oh and finding someones old tube doors i dont think is gunna happen cause ive never seen built 4x4 explorer here my whole life

 

[94Gexplorer]

if you can weld you could find a couple blazer ect tube rear tire carrier and make it fit then put some net or mesh wire on it so stuff doesnt fall out ive seen this done on some jeeps