Superlift and Skyjacker in One?

[Makahveli]

O.K. I know I maybe shouldn't do this but I bought a 6" Class II Skyjacker lift minus the Pittman arm and extended sway bar links. I went to 4wheel parts and they told me that some of these parts are interchangable is that so true? I went on and bought the Superlift Pittman arm and the links, then they told me for the links there are Sway bar relocation brackets again from Superlift. So now I got there brackets that I don't know whart the hell to do. Do anybody out there know? Oh and of course I'm doing a spring over axle in the rear.

 

[zensius]

I'm sure the parts are interchangeable. The steering is an independent system. As long as the drop is enough it will work. The sway bar this is the same as well. It doesn't interact with any other part of the new suspension so it should work fine. BUT...I put the Superlift 5.5 on and I thought the front sway bar extension was junk. Since I wasn't going to run the rear bar I used those extensions instead. They work great.

 

[Makahveli]

So with my rear factory sway bar links will work perfectly to be in place of my front sway bar links on a 6" lift?

 

[zensius]

No, the links that came with my superlift 5.5 for the rear work in the front. Did the Skyjacker come with rear sway bar extensions? The front extensions that came with the 5.5 were actually just 2 inch square blocks that attached to the frame to lower the mounts but I didn't like that. So I did what I did.