Tach and battery gauge

[93ebx]

I decided to start another thread just in case people got tired of reading the last

Here is the issue, the tach is dead and the battery gauge reads nothing. Everything works just fine

What I have done:
Fuel pump and filter
Unplugged replaced to check ignition coil-returned new one
Crankcase Position sensor
New radio
New positive battery cable

would these have anything to do with these gauges not working, are there fuses associated with them?

Thanks for the help

 

[boggs1227]

where they working before ??? did you at any point when installing the radio did you take the dash trim off and take apart the guage cluster ? if you did maybe the 2 plugs behind the guage cluster could have come loose .

you can always go to a local yard and get a some new guages if all fails .other than that all i can say is check your fues box ( both ..under the hood as well) .

could also be that the tach maybe just stuck.does it move if you tap the dash when the engine is running ?

 

[93ebx]

Yes they all worked before and I did not take any of the gauges off. The only thing I was thinking with the radio was I may not have some of the wires from the truck harness connected but all seems to work with the radio. And I am not sure if after checking the Ign Coil/replacing the CPS or replacing the radio it went bad. I will check fuses. Also The harness on the Ign Coil looks a little skinned up but it seems to be working fine.