J_Train
Well-Known Member
- Joined
- July 21, 2010
- Messages
- 585
- Reaction score
- 9
- City, State
- Citrus Springs, Florida and LaGrange, Georgia
- Year, Model & Trim Level
- 00 xlt v8
Is it possible to wire in a 2hi 4hi 4lo switch and bezel from a 4X4 ranger/explorer and a 4x4 gem module to make the transfer case motor to operate correctly? basically can it be done with out needing a whole wiring harness and PCM GEM or any other modules from a 4wd ranger/explorer with same engine, trans, etc.? basically a stand alone 4X4 module. I converted my truck from 2wd to 4wd and wiring a transfer case motor is last thing I need to do since I was having a hard time fining a manual transfer case and shift linkage. sorry if this is confusing I hope someone can give me some help.