Transmission solonoid wire location

[NixieTube]

Hello, obligatory "first post"
I am looking for the wire that controls the a and b solonoid as well as the clutch lockup circuit.

I've got the center console out to have access to the top of the transmission.

Any help is greatly appreciated.

 

[wollimann]

Maybe this video helps you what causes your DTC's.

 

[NixieTube]

Maybe this video helps you what causes your DTC's.

Thank you but I don't think this is it, I was canging out o2 sensors and likely disturbed one of the wire harness and loosed a connection, because they all failed simultaneously without warning, problem is is I don't know where the outside plug in or wire for solonoids is

 

[wollimann]

problem is is I don't know where the outside plug in or wire for solonoids is

The plug is not on top of the transmission, i think it is on the rear passenger side of the tranny.
Maybe you gain access from obove, maybe not...

 

[Turdle]

Thank you but I don't think this is it, I was canging out o2 sensors and likely disturbed one of the wire harness and loosed a connection, because they all failed simultaneously without warning, problem is is I don't know where the outside plug in or wire for solonoids is

2nd gen issues? Try this first!

Sometimes a gremlin can be caused by the smallest thing. There are 2 large wire bundle connectors on the firewall. Both are held tight with a 10mm bolt. Any bad connection in either plug can cause just about any issue. from bad transmission shifting, bad o2 sensor readings, no start, no...

www.explorerforum.com

Maybe this will help

 

[C420sailor]

Yeah those wires are all in the same harness…transmission and oxygen sensors

 

[NixieTube]

Yeah those wires are all in the same harness…transmission and oxygen sensors

Solved, after looking hard at some diagrams I realized I was an idiot and it was literally right in front of me.