Hi, I am here trying to help and get helped.
This is how to hook 791xv to your 04-05 Explorer. After alot of research, I came up with this wiring diagram and wondering If some one can look it up and correct me if I am wrong in any wires. Plus I don't know How to connect extra sensors to the alarm and not 100% sure about the window roll up & down.
Thanks In advance and Happy holidays
H1
12 ORANGE Planning to connect 530T window roll up with 87 relay.
11 white ---------------- BROWN (+) HEADLIGHT SWITCH, GRAY Plug
10 WHITE/BLUE Not used
9 BLACK/WHITE - Not used
8 Green--------------------------------BLACK/LIGHT BLUE (+) Door trigger input
7 Blue----------------------------------PINK/ORANGE - Trunk trigger input
6 Violet Not used
5 Black/Ground CHASSIS GROUND POINT
4 Empty
3 Brown Siren output + I hooked this wire up to the red wire that comes off your siren.
2 Red 12 VOLT CONSTANT Yellow IGNITION SWITCH HARNESS, BLACK Plug
1 Red/White---------------------------ORANGE/LIGHT GREEN (+) or PURPLE/YELLOW (+), Requires Part #87 Relay
H2
1 L. Blue 200a (-) This is if your car have to push once to unlock and 2nd to unlock the rest of the doors
2 White/ Black 200a(-) channel 5 output Can I connect this to the Tilt sensor
3 VIOLET/BLACK - 200a(-) channel 4 output Can I connect to the glass sensor
4 Green/White FACTORY REARM Not used in ford
5 Gray/Black Not used in ford
6 L Green/ Black (-) factory disarm (GREEN/VIOLET - "HARNESS UNDER
DRIVERS SIDE DOOR SILL PLATE)
Door Lock Harness, 3-pin Connector
1 GREEN ---------------------------PINK/YELLOW Lock +
2 Empty
3 Blue +------------------------------PINK/LIGHT GREEN Unlock –
Remote Start Primary Harness, 7-pin Connector
This connector plugs into the relay satelight and then into the alarm.
1 PURPLE(+) ------------------------RED ( Strarter side)
2 GREEN------------------------------RED ( Key side)
3&6 RED(+)--------------------------YELLOW (+)
4 ORANGE(+)------------------------DARK GREEN/L GREEN (+)Accessory circuit
5 PINK(+)------------------------------RED/LIGHT GREEN (+) Primary ignition
7 PINK/WHITE(+) -------------------Not Used
8 RED/WHITE(+) -------------------Not Used
H3
1 blue/white----------------------------GRAY/BLUE - Defoger - REAR DEFROST SWITCH
2 GRAY(-)------------------------------Hood pinswich Input, zone 1
3 BROWN(+)---------------------------TAN/BLACK (+) or LIGHT GREEN (+) brake shutdown wire
4 VIOLET/WHITE I don’t know what wire to hook up Need help May be (PINK/WHITE) in IGNITION COIL PACK
5 BLACK/WHITE(-)-------------------Planning to Ground it.
H4
1 brown(-)----------------------------YELLOW/LIGHT GREEN (-) or YELLOW/LIGHT BLUE (-)
2 Orange/Black Not Used
This is how to hook 791xv to your 04-05 Explorer. After alot of research, I came up with this wiring diagram and wondering If some one can look it up and correct me if I am wrong in any wires. Plus I don't know How to connect extra sensors to the alarm and not 100% sure about the window roll up & down.
Thanks In advance and Happy holidays
H1
12 ORANGE Planning to connect 530T window roll up with 87 relay.
11 white ---------------- BROWN (+) HEADLIGHT SWITCH, GRAY Plug
10 WHITE/BLUE Not used
9 BLACK/WHITE - Not used
8 Green--------------------------------BLACK/LIGHT BLUE (+) Door trigger input
7 Blue----------------------------------PINK/ORANGE - Trunk trigger input
6 Violet Not used
5 Black/Ground CHASSIS GROUND POINT
4 Empty
3 Brown Siren output + I hooked this wire up to the red wire that comes off your siren.
2 Red 12 VOLT CONSTANT Yellow IGNITION SWITCH HARNESS, BLACK Plug
1 Red/White---------------------------ORANGE/LIGHT GREEN (+) or PURPLE/YELLOW (+), Requires Part #87 Relay
H2
1 L. Blue 200a (-) This is if your car have to push once to unlock and 2nd to unlock the rest of the doors
2 White/ Black 200a(-) channel 5 output Can I connect this to the Tilt sensor
3 VIOLET/BLACK - 200a(-) channel 4 output Can I connect to the glass sensor
4 Green/White FACTORY REARM Not used in ford
5 Gray/Black Not used in ford
6 L Green/ Black (-) factory disarm (GREEN/VIOLET - "HARNESS UNDER
DRIVERS SIDE DOOR SILL PLATE)
Door Lock Harness, 3-pin Connector
1 GREEN ---------------------------PINK/YELLOW Lock +
2 Empty
3 Blue +------------------------------PINK/LIGHT GREEN Unlock –
Remote Start Primary Harness, 7-pin Connector
This connector plugs into the relay satelight and then into the alarm.
1 PURPLE(+) ------------------------RED ( Strarter side)
2 GREEN------------------------------RED ( Key side)
3&6 RED(+)--------------------------YELLOW (+)
4 ORANGE(+)------------------------DARK GREEN/L GREEN (+)Accessory circuit
5 PINK(+)------------------------------RED/LIGHT GREEN (+) Primary ignition
7 PINK/WHITE(+) -------------------Not Used
8 RED/WHITE(+) -------------------Not Used
H3
1 blue/white----------------------------GRAY/BLUE - Defoger - REAR DEFROST SWITCH
2 GRAY(-)------------------------------Hood pinswich Input, zone 1
3 BROWN(+)---------------------------TAN/BLACK (+) or LIGHT GREEN (+) brake shutdown wire
4 VIOLET/WHITE I don’t know what wire to hook up Need help May be (PINK/WHITE) in IGNITION COIL PACK
5 BLACK/WHITE(-)-------------------Planning to Ground it.
H4
1 brown(-)----------------------------YELLOW/LIGHT GREEN (-) or YELLOW/LIGHT BLUE (-)
2 Orange/Black Not Used
