no codes

Hey y'all. I gotta '02 explorer from a guy who told me after running hot he kept on driving a good bit in order to get it home. So I thought I'd be fixing an overheating problem but what he didn't tell me is its not running at all. It will crank and start some but shuts off immediately. Its...

I've got a 95 XLT 4.0 OHV 4x2, and the O/D light is blinking and it won't shift into overdrive. It didn't start flashing the O/D off light until one day when I was pulling a trailer with only a push lawn mower in it. (nothing heavy) I figured that connecting the trailer to the plug that supplies...

1998 Explorer Sport 4x4 104,000 miles 4.0 OHV 5 Speed Automatic I've had a problem with a serious misfire that randomly started a few weeks ago.There are NO codes or CEL Truck starts fine and idles good, I can accelerate at grandpa speed and all is good. As soon as I open the throttle 50% or...

I stuck this post here as I think I am out of the realm of the “Stock” portion of this forum: I’ve got the build listed on my website (MidwestNomads) and over on Pirate 4x4 if you want the full on details of the build. In a nutshell, the motor is the only part that hasn’t been touched...

I have a misfire and rought idle that is very repeatable after about five to ten minutes of warmup. No DTC codes are set. I bought the ScanXL software from Palmer Performance Engineering (PPE). I was surprised to discover the data collection (USB) device that I bought from Amazon was...

Hi I'm Chris. I've got a 2002 Explorer 4x4 with a bad 5r55w. It had the failed servo bushing issue. It had a broken servo, and a broken band. So I pulled it out, and rebuilt it. I replaced the case with one with brass bushings, installed new steelies, clutches , the upgraded shift kit and new...

I have an '03 Explorer, 143,000 miles, and it makes a clattering noise that rises with rpm's. No codes. I tried removing the belt, but the noise is still there. The timing is rock steady at both the #1 and #4 cylinders. What is going on? I don't want to drive it until I figure it...

Hi everyone! Thanks for all of the posts and advice in this forum! Ok, I have a 2001 Explorer XLT, 4.0 SOHC V6, 2WD A/T. It has been great with almost no maintenance or wear issues for 167,000 miles. Then one day it would not start. It ran fine one night, then would not start the next...

Hi everyone! I have been reading this forum for a while, and the exchange of information and maintenance tips has been great. But now I have a problem. “01 XLT 2WD 4.0 SOHC A/T was running fine as usual, parked it at home, then the next AM it would not start. There was No CEL showing...

Hello, I have a '98 Explorer XLT with 4.0 SOHC. I am having an issue with a rough/maybe even low idle when warm. Usually occurs when sitting at traffic light. Just a rough idle for a couple of months now. Tach reads around 600 at warm idle. Engine performance is great/smooth above 1k rpm...