Search results

My battery was going bad but even with a jump the engine would turn over. I put a new battery in today and it doesn't make a sound. I think I can hear the fuel pump go on. I have 1 key and 2 key FOBs. The key FOBs both work but still can't get it to turn over.

I have a 2004 Explorer with dual climate control. I recently replaced the engine and now the flow controls aren't working. They were working before I replaced the engine. I checked the vacuum on the line in the engine compartment and it has vacuum. Why aren't the controls working?

I need to remove my rear drive shaft. I don't have any 12 point sockets so I need to know the bolt size on the drive shaft so I can get a 12 point socket tomorrow.

I'm trying to get the top 2 transmission bolts out. I've seem some people remove the transmission support but there's a bolt to close too the exhaust pipe and another bolt for a heat shield too close to the exhaust pipe. I've see other post saying there is an access panel under the center...

I'm replacing my engine. I wanted to know if there is an easy way to get the upper transmission bolts out on a 2004 2.6l AWD Exploder Limited

I'm sure this has been asked before yet here I am... I'm removing my engine and need to know how do I get access to the torque converter bolts? The engine is seized i think it's a rod. I was told to turn the engine backwards but I'm afraid the harmonic balancer bolt my come out. If I can't turn...

I have a 2001 Eddie Bauer Explorer. Having a problem with the A/C. The compressor goes on and off and I can see the pressure change so I assume that part is working. Problem is no air flow to the vents, some warm air to the defrost, rear A/C is warm. I pulled the controller out and took the...

What would happen if I used R134a in a stock 1993 Explorer R12 system?

I recently installed "ALL" new A/C parts. I took it to a shop to charge the system and they could get about 40 or 50 on the low side and only about 120 on the high side. The company I bought the compressor from wanted me to take it to a "chain" shop that would know what was wrong with it so I...

I just put "ALL" new A/C parts in. I know some about A/C systems but not operations. I've restored hundreds of 1967 to 1973 in-dash Mustang and Cougar A/C systems but never installed or charged them. I've installed "ALL" completely new parts in a 1992 Mustang and 1994 Mazda B3000 but had someone...

I had a problem with the liftgate being slightly higher than the roof line. I loosened the 2 hinge bolts on the hinges and the gas shocks forced the gate up the hinges and didn't realize it and lifted the gate up and the edge of the deck hit the roof. I had to pull the shocks off to move the...

I have a 1993 Explorer 2 door Sport. Some time in it's life the engine was replaced. I was replacing all the A/C parts today and came across this part hanging by a single wire in the engine compartment on the driver side. What kind of dang deal is it and where does it go. It looks to go in a...

I recently purchase a 1993 Explorer Sport that has see better days. It has no interior door panels driver side door doesn't have a window regulator. It had no problem the first day, the doors locked and unlocked with the controls on the doors just fine. I closed the door and they continued to...