Search results

I have a Surco roof rack with the spare tire mount that I need to sell. Roof rack could use a new coat of paint, little bit faded, but other than that its in great shape. First $50 bucks picked up gets it, not looking to ship, way to big for that. Can get some pics if interested. Also have a...

I replaced all my brakes on the '01 Sport a couple weekends ago, went all out. Here is what I replaced: Rear pads with premium Rear antirattle clips Front rotors with new Motorcraft Front pads with premium ceramics Front antirattle clips Front slide pin boots Front bearings with new...

I am eyeing the xspec handling kit for my '01, and am wondering if anyone else is still using this setup? My truck is strictly road use, and am looking to get the slop and wallow out of this thing going around corners. I already replaced the shocks, just gabrail ultra's nothing fancy, and...

My '01 Sport has a weird problem, the accelerator cable has a lot of slack in it, I can pick up the cable itself, metal not the casing and pull it up about half a inch before it moves the butterfly or the pedal itself. Inside you can push the pedal about half inch down before there is any...

I have sold my '92, but kept a few things from it to sell seperatly: First is a set of four like new 32x11.50x15 BFG A/T's mounted on also like new Mickey Thompson black Sidebiter rims 15x8 . These were bought last july, but only around 2k miles on them, never been off pavement, (which is why I...

I went to install a rear backup camera because of limo tint and switching to the night shift at the job. So, get it all wired up and realize the damn lights are not working at all, dont know for how long, may be up to a year ago. So here is the symptoms, there is no juice to the sockets...

I have noticed that from time to time my speedometer will all of a sudden jump and hold a higher than right speed. Yesterday I was on my way to work, getting on I35, had to rapidly accelerate to about 70-75, not punching it but getting on it alittle more than normal. So I settle to a 70mph...

I have noticed that my gas pedal has a lot of play in it, back forth, and side to side. So I looked where it is attached to the firewall, at the pivot point, and it appears the bushings are pretty worn out. Has anyone replaced these, and how involved is it? Also where did you find the new...

Ok, I drive to the store last night, come back out and the clutch is gone. The pedal is soft halfway down and then hard as hell the rest of the way. Even getting it to the floor wont let you shift into gear. Had to have it towed back to girlfriends house. Here is what I have, New trans, new...

I am installing a 99 rear axle on my 92, everything was going great till it came time to bleed the brakes. The pedal is VERY stiff, the fronts are bleeding like they are supposed to, but the rears are getting NO fluid. I have taken the entire rear brake hose off, just open steel line, and get...

I found out today while reinstalling the transfer case, that this loud clunking noise that I have been hearing for awhile now, is coming from inside the transfer case. Basicly the noise is a pretty loud clack noise when ever you turn either yoke and then change directions. It happens in all...

I have been noticing lately that I am having a little issue starting. Sometimes when I cold start the truck, it will crank for a couple seconds before starting, however when it does start it runs great. Its only on cold starts, and does not do it everytime. I had a issue a couple weeks with...

1992 Sport 4x4 5spd. I am in the middle of changing my m5r1 for a new rebuilt, I have spent all day removing the eight bolts that hold it on. Now it is loose and I have found that I cannot remove the trans because of the exhaust y-pipe is in the way. I cant get to the bolts that hold the y-pipe...

I have been debating swapping my rear axle for some time now, and have recently found a possible local donor. It a Explorer axle, from a '01 Sport, wrecked in the front, no rear damage, engine was not pushed back. Axle code is D4, which is supposed to be a 3:73 Limited slip. There is only 75k...

Ok, I am finally getting around to replacing my trans and clutch, along with the main rear seal. I have not picked out a clutch yet, and need some advice and some answers. First off, why is a 91-92 clutch different from a 93-94? I cannot find the difference listed anywhere. Is it spline...

I am in the middle of installing a new 2 way Alarm on my Sport, and have run into a little problem. For the dome light to come on with the disarm, which the old alarm did also, it has to be hooked up. The old system used one wire for the door triggers and the dome light, with a seperate +12...

Ok, my rear seal is leaking pretty good, at 104k, I guess its about that time for a new one. I am wondering what all is involved it replacing it. I know that the trans has to be removed, and the converter/flywheel, or in my case the clutch/flexplate, to get at it. My chilton claims it can be...

Title says it all, after a measly 10k miles on my rebuilt M5od, the 5th gear has decided to develop one hell of a knock. So much for the standard being more reliable than the a4ld. After listening to some shops, I have come to the conclusion that I will self install the next one, as the prices...

Does anybody know where I can get a new brake booster check valve grommet? I found out tonite where that hissing I have been hearing is coming from, the grommet is literally falling apart. I tried the usuals, local parts stores, ebay, online ford parts sites, and nothing. You get one when you...

I am getting ready to have my 5spd worked on here in the next couple weeks, and am thinking of upgrading the clutch at the same time. The clutch I have is newish, but stiff as hell and slips alot under torque.j So I am looking at the Centerforce dual friction clutch kit, and am wondering if its...

I am having a weird problem, my truck has the mazda 5speed 4x4 trans, rebuilt unit installed about 2 years ago, and about 8k miles on it. I recently took a 600 mile trip to the coast in it and when I came back about a week later the trans was ticking in 5th gear. NOTE, it only ticks in 5th and...

I or actually my brother needs help trying to get his truck to pass inspection. Its a '96 Ranger, 3.0 5spd. He managed to get the codes that are showing up, they are: p1443 Manufacturer Contrl. Auxiliray emission Controls p0133 02 Sensor CKT Slow Response (Bank 1 sensor1)...

I havent had to do anything to the Explorer in awhile, been running great 'cept for a wore out starter. However I am getting a little worried about the rear driveshaft, everytime I reverse directions it clacks. I know where its coming from, the slip yoke, I replaced the ujoints when I first got...

Seems my oil pressure guage is a little lower than normal, actually its sitting on the "o" while its usually on the "r". Not the end of the world, but I have noticed that the guage is not moving, even when you cut the truck on and off. Can someone tell me if their guage drops with the key off...

Ok, first off, the ac system in my '92 is new, installed by the stealership 3-4 years ago, less than 5k on the system. P.O. paid big bucks for new compressor, condensor, dryer, hoses etc. Everything worked great till this summer, when I noticed it just wasnt getting cold anymore, put a guage on...