Search results

I just looked over the instructions for the borla headers and on the diagram it says flare to 2.50 where the down pipes meet the headers. Does that mean that I have to flare this part of the joint to 2.50? I know it is already flared, but is it flared enough. I would think that if it was already...

Hey, I really want to improve the ride of my 93 explorer xlt. I bought those x-spec 1.3 inch sway bars from explorer express and the ride is just too rough. I really liked it at first, but then its just soo anoying. So this is what i'm planning on doing. Progressive 1 inch raised coils up...

I have a couple questions. I have 30x9.50 goodyear at/s on the stock rims. How come when I took a tape measure and measured them they are only 29" tall and 7" wide? One last question could I use these tires on 15x8" rims? Any replies would be greatly apreciated! I know these questions probably...

I have a rough idle and it used to stall when i first turned it on and put it in reverse. It is a 4.0L 93 OHV. I recently replaced my head gaskets and all the other gaskets that had to be replaced to get to the head gaskets because the engine was using coolant. I also noticed a whole lot of...

After reading another post about how to check to see if your fan clutch is working properly I went outside to check. There is resistance when i turn the fan when the engine is cold and the same resistance when the engine is warm. When I turned on the engine I watched the fan and it never stopped...

I wanna know if anyone has opinions about the wrangler at/s's beachin ability. Also what pressure should i run them at on the road? Thank You for any replies. -Chav

OK I have patiently waited for my headers for almost 2 months (since 3/23/00). Every so often Carparts.com decides to send me an estimated shipping date that is a couple weeks away. After recieving 4 or 5 of these I am really starting to get annoyed. I dont think i will be a customer of...

When I was taking off the fuel rail on my 93 ford explorer 4.0 a couple of the fuel injectors came with it. A lot of mud and grease was on the intake manifold and I can see peices of dirt on the ends of the fuel injectors. Some of the dirt might have gotten into the fuel rail. What should I do...

Now I have really gotten my self in some deep stuff. I am in the middle of replacing the head gaskets on my 93 ford explorer. I have removed the passenger side head, and now I am trying to remove the driver's side head. The two bolts on the exhaust manifold closest to the fire wall are giving me...

I'm trying to remove the driver's side valve cover and the last bolt, that is closest to the fire wall is rusted so bad that my socket just spins on it. I'm gonna try and use a smaller size socket and hammer it on there, but i was wondering if any one has any different ideas in case the...