1999 ford

No reverse in a 99 ford explorer sport . Is it a easy fix ? What could be the problem?

I have a 1999 Ford Explorer XLT UR Model in Australia. Would anyone know what the following codes mean? PO122 = TP-CKT low output P0123 = TP-CKT high P1125 = TP sensor intermittent Thank you :)

My engine light came on. Went to auto zone and they told me cylinder 1 is misfiring. Tried to change it and couldn't. Going sat to get it done. went to drive today and the engine light started flashing, but it doesn't constantly flash. Mostly flashes when going up hill. when I level out it is a...

I am planning on changing out the transmission filter and doing a drain/fill of the transmission fluid. Would do a full flush, but the truck's got 185k miles on it, so I'll be changing the fluid nice and slow-like. What transmission do I have (need to order the right filter kit)? What is...

I followed the steps for checking my transfer case by jacking up the truck and putting it on jack stands. The wheels turned just fine. I was able to turn the front driveshaft by hand while in 4High and idling. It seems though that 4Low actually works because I hear a clunk from the front end...

I have some problems with my power antenna. The power antenna motor works just fine, I can hear it working when I turn the radio on. If I turn the radio off and then push the antenna stick down, it goes down. And when I turn on the radio again it goes up, but not fully extended. But then it...

Hello all! First off, I'm a brand new happy owner of a 1999 Explorer Eddie Bauer V8! SO excited for the things to come with this truck. I have a little bit of a problem however, the CD Player lights don't work at all (sometimes they brighten up really quick and then go back out again) and the...

Hi, Has anyone ever done a thermostat housing replacement on a 4.0 SOHC? I have been looking for a step by step instruction on youtube, but have not been able to find one. I also have misplaced my chiltons manual. I have had a 2000 ford explorer since almost new and love it. I...

Warning-First time poster. I'm working on my daughter's 1999 3.0 liter Ranger 4x4 repairing a blown valve body gasket. I broke the pin on the "rooster comb" part, found a replacement at Pull a Part, but am having trouble getting the spring loaded rod that the "rooster comb" connects too, back...

Are the bolt patterns different or will it still fit.

Recently my temp. gauge has not been going up to normal. Researched a little and think it is the thermostat. Coolant level has not gone down at all. How hard of a job is it to do? How can you tell if your thermostat you have now is broken? Would it be worth just taking it in? Thanks!

I found a 1997 rear bumper for really cheap but will it fit a 1999?

Hey guys I have a 99 explorer 5.0. I recently replaced my fuel pump and now it runs great. I just have one little issue left. My truck has a vibration. It is when I am idling or cruising. It isnt noticable when Accelorating. I have been told that it could be a motor mount or maybe an injector...

I am currently working on getting my 99 explorer 4x4 road worthy and then I will get it off road worthy :D. I was underneath it for this past week changing out rotors, brakes, dust shields, calipers, caliper bracket, parking brake springs and shoes, and shocks. Looking underneath the rear end of...

I have a 1999 Ford Explorer w/ the P0750. P0755, P0760, P0765 trouble codes. I got these codes after doing a valve body separator plate (w/ bonded gasket) replacement. I KNOW I connected all of the electical connectors to solenoids. My research to date indicates that the first things to...

I have an Audiovox Prestige alarm/remote start system in my 1999 Explorer with keyless entry. The lock pulse from the alarm is programmed to a 1 second pulse, which is the shortest lock pulse setting that can be programmed. The issue I'm having is that when I lock the doors using the alarm...

Im looking at buying a 1999 ford ranger, and it has a spacer 2inch lift, and there was one thing that concerned me about it. While driving the car i noticed that the steering wheel was a little crooked, and I asked the guy about it and he said it was because of the lift. I took my hands off the...

SUCCESS! blower wheel shatterd due to vibration 1999 Ford Explorer LTD This is an update - I figured why start a new thread so I would just update this one. I went out to the truck after my original post and fired up the heat and heard the blower wheel blow apart :eek: Now the blower motor...

I need to remove the air filter assembly ( actually the air filter box the filter sits in) in order to gain access to a hold down bolt on the coolant reserve (the coolant tank and washer fluid tank are a one piece unit) which is on the sloped part of the fender and is impossible to get to...

My horn stopped working after blowing at another driver, and I used the back wiper one time and it stopped working. Can you help...

Hey all, I need some help with my daughter's 1999 Ford Explorer Sport 4.0 SOHC. Fuel Pump help that is. Read many threads and learned alot but I am missing something. She turns ignition on, hears the PCM click, fuel relay click, fuel pump whirrrr. All is great. A few hours later after it has...

I found out firsthand today why tune-ups are so expensive. On the 1999 Explorer with the 4.0L V6 SOHV, the plugs are a bit of a pain to get to, especially on the passenger's side of the engine. I have a Haynes manual for my vehicle; I found it was vague on what would be involved to change the...

I need to replace the blower motor but seem to have a conflict with part numbers . I have the Ford shop manuals for my truck and the part number for the motor is listed as 18527 but when I do a google search the only exact hit I get is for a place listing it for a 1996 Explorer - would this...

I am very confused i have installed a 530T in my 1999 ford explorer but i can only get the passenger window to work and it works perfectly.. the drivers window has "one touch down" from the factory and i an not sure how to wire the 530T to get the drivers window to work, when the driver window...

Hi folks, I need some help! I have a 1999 Ford Explorer with a 5R55E Transmission. It was given to me as payment for a contract that was owed to me. I started driving it and realized it was stuck in 4WD Low. Upon further testing, I went ahead and changed out the Transfer Case Motor, which fixed...

Have a 1999 Ford Explorer with a 4.0 liter SOHC engine, 129K miles on vehicle. Yesterday morning it would crank easily but it would not start. Checked fuel rail - had fuel and it was pressurized. No problems before this non-start. Ran OBD code tester tests - response: No communication with ECM...

Hey everyone, It's been a while... I have a 99 Explorer XLT 4.0L SOHC That will not start! It acts like its not getting any fuel but it has adequate fuel pressure and I can hear the fuel pump running. It has ran just fine and hasn't shown any signs of any problems, but yesterday I got off...

Greetings everyone. Unfortunately my first post is a plea for advice/help. A couple months ago, while driving, the “O/D Off” light began flashing. Of course my first instinct was to toggle the button but that didn’t work. It stopped after I parked my car and turned it off. It didn’t happen...

Well it started as a thermostat issue so i thought or the heater control valve so i replaced both it ran fine for three days and overheated when i turned on the heat and so i figured it wasn't going through the thermostat. so i took it back out and no coolant came from housing tested thermostat...

Sorry if I put this in the wrong place. I need help. My Explorer randomly started running hot yesterday. I come home park, went out about 30 min to get a tail light bulb from autozone and it started running hot. Today I went to the store and on the way there it was fine. I left and while idling...

Please if you have a big photo , send me to joselosurfing2004@yahoo.com . Thanks

Hi All, new to this site. I am trying to find where the washer pump is located on a 1999 ford explorer? I have the Haynes book but not in there. thanks for the help

I recently bought a 1999 ford explorer that has been sitting for an unknown period of time. We put a new battery in it and some gas and it attempts to start but wont. It starts when we spray starter fluid in it but when we stop it shuts off. Anyone know the best thing to do? I suspect fuel pump...

Have replaced the battery and the starter relay. When you turn the key the starter clicks. do I need to replace the starter.

jacked up car did the test to make sure drive shaft would turn the wheels .They turned. So diff is not locked . spun wheel 1 turned 1 way 1 turned the other way .So i am posting a new tread. vary good info thanks

i am replacing the fuel pump in my explorer and the (i think is the return line the on on the sending unit outside the tank with the quick disconnect the fitting broke) i need help getting it fixed.

Ok I just bought this truck for next to nothing from a family friend. Its jam up perfect. But it has a few minor issues. One of them is annoying. My ABS light is on. I know I need to get it checked with a body and ? scanner, but is there a simple way to reset the light and see if it comes back...

I have a 1999 Ford Explorer XLT V6 with 148k miles. Whenever I accelerate from 1st to 2nd the engine races until I let off the accelerator. After I let off the accelerator and allow the truck to get into the next gear, it will allow me to accelerate properly. I had the transmission flushed and...

I have a 1999 Ford Explorer V8 5.0 2WD four door. I need to replace the rear end. I have an option to buy a rear end off of a 1997 V6 4.0. Does anyone know if this is compatiable? What do I need to look for in matching up the right rear end for my Explorer? Thanks.

I got it! It seems like it has pretty much every option available except for leather and it has some sort of premium sport package (?) with a spoiler and everything up top. Also, it's my first vehicle with 4 wheel drive, which I get to enjoy under the 4 inches of slush/ice here in Stafford, VA...