emissions

Hello i am new to this Forum and looking for advice from y'all gurus. I bought a complete 2000 explorer 4.0 sohc eddie baure eddition 2wd. -I will be doing a complete motor, trans, PCM and harness swap from this explorer to a 93 Ranger and looking to get away with not using the steering...

Where is the emissions decal on my 2003 Mountaineer? Under the hood is the belt/pulley and refrigerant decals, but that's it. I need to order catalytic converters & need to be sure I don't have CA emissions.

Hello, NEED HELP! enquiring about a temporary solution for the holiday season, Parts are difficult to find here in New Zealand! I have had my 05 v6 XLT Explorer diagnosed, misfire piston 1 and a number of error codes, replaced the plugs, (looked like the originals!) then narrowed it down to the...

I recently purchased a '96 Ford Explorer Sport 4x4, w\233,000 miles on it. Took it to emissions in order to register and title it, and it had 4 trouble codes, P0401 insufficient EGR flow P0402 EGR flow excessive at idle P0340 camshaft position sensor circuit malfunction P0420...

Hey everyone, I got a code P1443 a week ago, so I got a new canister purge solenoid (google BWD CP509 to see the part I got). After searching this forum, I was finally able to locate the existing valve below the air filter housing. I replaced the valve, but the vacuum tubes connecting to it...

I just had a rebuilt 4.6 installed in my 02 Explorer. There's stress a few kinks that need to be worked out. I was wondering if someone can lead me in right direction. Since the swap, I've been getting the check engine light and check fuel cap. The code is for evap emissions. The...

I'm about to replace my catalytic converter, I'm basically replacing anything and everything on my 91 XL to help get it running better and improve my MPG. This truck has about 166k on it, and it's time to follow up and replace things that are likely to be getting in the way of top performance...

I have a 1993 Explorer and the EVR voltage is out of range ( code 335). The EVR voltage should receive between 4 to 6 volts. I tested the connector to the EVR, and it was receiving 14 volts. How can I fix this problem?

My check engine light came on. I checked the codes. It showed an EGR system code, not exactly sure which one off the top of my head. I replaced the EGR valve and DPFE. Reset the computer, and it still popped up. SO i replaced the EGR vacuum solenoid. Cleared the codes again. Still comes...

Ok, I'm sure this topic has been covered but I can't find it here on the forum. My 1993 4.0L is pinging under load, either uphill or under prolonged acceleration. Unfortunately I cannot troubleshoot the pinging (I believe due to timing) because I didn't get the Ford Powertrain/Emissions...

I have a 91 explorer. Last year I had trouble passing the TN emissions because of high HC. Rebuilt the engine, valves and all. Doing that made the HC to 64 and passed. Now again this year it failed again. Put new wires and plugs. Clean the intank, TB, MAF, IAC, intank air temp sensor. Checked...

I have just bought a 1984 B2, now i'm wondering witch carb i should get or what emissions i could take off of my factory Motorcraft 2 Barrel. I would like to keep the factory but it likes to stall at any steep hill

:p: So, I purchased this used '96 XLT from a "honest-looking" farmer. I didn't notice that a portion of the paneling had been opened and won't close on the bottom left of the steering wheel. Then, I notice that my tempature gage won't work. It barely registers after running for awhile. After...

Hello I am new to having a Ford Explorer. I love the truck..I bought it at an auction so I took a chance. A few things have come up I am hoping the experts here can help me with. I bought it with check engine light on..truck runs great. It has the 4.6LV8. I took to get inspection sticker here in...

I am needing some help and guidence at what might be causing my Ranger to have high levels of NOX which is keeping it from passing California emissions. The truck is in excellent condition for it's age, and I have always maintained it. I have only replaced the catalytic converter one time, and...