motor

From what i can tell, the one touch has different connections than a regular motor/regulator. Mine has an eight pin connector, not two. the regular motors have a 2 pin connector. that ford number is 2010 Ford AL2Z7823395-D. I know regulator/motors are all over the internet, but i have...

Typical Center Console/98 XLT, no special options. We need a rear a/c blower motor ... where to get good one? I've acquired three so far with inoperative motors ... bummer. Are these possibly serviceable? Need to keep Nana happy and grandchildren in comfort. Thanks for any help. Greg / Florida

I ****ed my frame up i go through about 6 sets ofnsway link endds a a year a buddy had a 2000 with a bad motor good trans what issues eill o rum intp puyting my motor and ecu into that ride

All I need is the small plastic cogs or pins not sure of their name. But if you take a power window motor apart there is a metal gear that sits inside a plastic gear. Those cogs are inside the triiangular hole that is between the two gears. Gears are ok.

Looking to see if Anyone knows if there’s an engine that fits the stock tranny on a 2000 Ford explorer XLS. And if not the cheapest website to find a 4.0 v6 DOHC engine refurbished. Worried the cassette’s on my timing chain haven’t been changed since the Vehicle was purchased in 2000.

My Explorer is 2006. I do not have the "turn dial" fan or temperature knobs on the dash. I have the up and down arrows for dual climate control. My fan is stuck on full blast. All of these forums and YouTube videos make it look so easy to locate, remove and replace the blower motor resistor. I...

So my 96 5.0 is getting pretty tired and it' time for a rebuild, but since it's my daily driver I am looking to buy another motor to build and swap in to minimize downtime. The question I have is what problems will I run into if I get a later model 5.0 to build? Ideally I'd like to find another...

Hello! Seems like my engine has some wiggle room. When I start the truck -- or shut it off, for that matter -- it sort of "shakes"... When idling, there's an occasional, unpredictable shaky feeling as well. It's not necessarily that it runs rough, but it's like SOMETIMES, some of the...

My 2005 Trac has the rear sliding window and that's it. the window regulator, rails, motor, and any other associated pulleys, fasteners, etc., are all missing. I don't even know what to properly call all the parts. Is there a term that implies all as a group? Is there a site where I can...

Using that popular guide on this website I have tried a few times to conquer the task of changing the bushings in my motor gear for my '92 Explorer Sport. I am mechanically inclined (not that this is a tough job or anything..) so the task as a whole should be a piece of cake... However, I...

2002 Sport Trac. I have replaced the back window regulator and followed the diagnostic procedure for the switch and believe it is functioning correctly. The old motor did not respond to the initialization procedure, so I purchased another. It also does not respond to either of the...

so my 1992 Explorer XLT wont shift into 4x4. ill push the 4hi button on the dash and nothing will happen, the light wont even come on. i was thinking it could be the shift motor but i'm wondering if you guys think it could be a more serious electrical issue.

I have a 2008 Ford Explorer. My sunroof will only tilt up. It will not come back down or retract. I removed the upper console to access the motor and was able to manually close the sunroof. I checked the fuses and all seem to be fine. I tested a few things and figured it was a bad motor...

GE Motor

GE Motor

As the title says i am sorry, im sure this has been covered a million times but i work to much to read thru all the threads. My 4x4 wont engage, i did have time to read about testing the 4x4 computer, did and it passed. No lights on dash or by buttons when pressed, where should i start? Im new...

Part 1 Hello everyone, This thread is intended to help Explorer and Mountaineer owners of only the year 1997 troubleshoot front blower motor failures. It was developed from working on a 1997 5.0L V8 Mountaineer and that is the only vehicle which I have tested it on. I am almost certain...

I picked up my 1998 ford explorer XLt with auto four wheel drive t case, about three months ago. After i picked it up i noticed if i accelerated really fast there would be a loud popping noise in the front end(while im in auto 4 wheel),(i dont know if it popped in 4x4 high) it sounds like...

New guy here that happened across your site while lookin for some help with my 98 Explorer. Seems like there are a lot of good people and great advice here. Lookin forward to being part of it all. I went to turn on the AC last nite and I have no blower in any mode...heat or AC. I do have...

Wipers move freely when I use my hands and the motor is running.So I am assuming that it is the linkage. How do get to the linkage ? And what parts need to come off ?

I just bought this old girl. Runs like a top but the windshield washer motor doesn't work. Pulled the plug and checked the voltage and it was only about 4 volts. What;s with that? I was going to put 12 volts to the motor to see if it was any good, nut decided I'd check with you people first. Is...

Ok, so here is the problem, about a year ago my blower motor stopped working, or at least I thought it did, when I turned on the fan from the switch inside it wouldn't do anything, a mechanic told me to try tapping the blower motor and if it kicked on it was the motor, well.... I did that and it...

okay here is the low down... i had 2 plug wires melt on my valve cover while traveling on the thruway.... obviously caused some problems.... fixed that(new plugs and wires) but now it will not idle for the life of it when its warm.... its standard, 4.0 OHV. i have no clue whats up.... i checked...

okay here is the low down... i had 2 plug wires melt on my valve cover while traveling on the thruway.... obviously caused some problems.... fixed that(new plugs and wires) but now it will not idle for the life of it when its warm.... its standard, 4.0 OHV. i have no clue whats up.... i checked...

This is the motor from a Craftsman cordless trim saw.

This is the electric motor inside of a cordless trim saw.

1989 ford ranger. the window will go down but i have to pull it up while pressing the up button. if i just press the up button the window wont move and the motor just whirrs. how can the motor let the window down and not take it up? is it the motor gear or switch?

Alright...so here's the deal. I have a 99 Explorer Sport with the 4.0 OHV with a 5 speed. My wrist pin is bad in my first cyl OR my crank shaft is starting to wear on the bushings with results in a rattling annoying ass noise. And the motor has 119K miles on it already, which would make it...

pic of destroyed window motor rollers

Box is motor electric connection, circled is hole to be drilled-1/2", arrows are existing holes