1350t-case swap into 95 explorer

[Travisjim]

will a 1350 manual shift t-case bolt up to my auto transmission ie bolt pattern splines ect not worried about linkage or driveshafts

 

[Glen4X4]

Yes it will bolt to your transmission if you're not worried about the drive shafts

 

[Travisjim]

thanks i was pretty sure it would. i found a guy with all kinds of ford explorer bronco II parts and he is going to round up all the parts i need to convert i didnt want to waste his time

 

[Glen4X4]

But I think you'll need to have a custom drive shaft made due to the output of that transfer case I don't think the BII shaft will be long enough.

 

[Travisjim]

ya i figured that i am getting the drive shaft with the t-case so just have to retube it

 

[Glen4X4]

Ok, good luck!

 

[Travisjim]

thanks ill let youall know how it went

 

[Glen4X4]

Sounds good.

 

[Travisjim]

picked up the parts this weekend did some measuring looks like its going to be a bolt in swap even the bronco II front drive shaft is going to work now all i have to do is get to work

 

[Gay-briel]

im running a bronco II 1350M in my 04 sport trac. Had to get the bronco's stock shaft cut down about 1.5 to 2 inches to work in my setup

 

[Glen4X4]

picked up the parts this weekend did some measuring looks like its going to be a bolt in swap even the bronco II front drive shaft is going to work now all i have to do is get to work

That's good to hear I didn't think the shaft would be the right length.

 

[Travisjim]

it might not be i just did a quick measure but shortning a shaft is easy enough.

 

[Travisjim]

well got it in went good gonna have to shorten front shaft 2 inches. took it for a test drive and in 4 low transmission doesnt want to shift out of 1st in D but will in 2nd but but who needs to go fast in 4 low i might get creative and mount some spring lever switches to t case lever so i dont have to manual switch the cad. hope to have it all done middle of next week can some one tell me how to put pics on here

 

[Travisjim]

everything is done wired switch to cad took out to pasture for a test run and first run through mud hole hydrolocked motor pulled plugs got runnin went throught hole all different ways everything worked great

any advice on moving air intake ?

Thanks for all the help guys great advice

 

[Glen4X4]

Sounds good did you take a picture of your driveshaft of what it looks like modified?

 

[Travisjim]

ya i have a pick but it wont let me upload it . i just used stock bronco II shaft shortened 2 inches