2006 trac & 4x4 on& not moving

[flathead]

I have another thread about this problem wanted to post an update and question though. After backing up putting the Expl in drive the trac light flashes and now the 4x4 light comes on (no ABS light though) It then does not want to move forward almost like I'm on the brakes and the gas at the same time. Can hear a chirping noise from the front. I heard it might be a front bearing (rear tone rings are fine) The left bearing is just a few months old. Have a scanner on order. But in the meantime I'm wondering if I un hook the connection to the abs sensor one side at a time then test it to see if it at least will drive to isolate the problem, would this work?

 

[flathead]

I have another thread about this problem wanted to post an update and question though. After backing up putting the Expl in drive the trac light flashes and now the 4x4 light comes on (no ABS light though) It then does not want to move forward almost like I'm on the brakes and the gas at the same time. Can hear a chirping noise from the front. I heard it might be a front bearing (rear tone rings are fine) The left bearing is just a few months old. Have a scanner on order. But in the meantime I'm wondering if I un hook the connection to the abs sensor one side at a time then test it to see if it at least will drive to isolate the problem, would this work?

Just pulled the ivd module fuse and the vehicle drives fine, ignoring the associated warning lights of course. Just wondering how to isolate the problem. Also heard the scanner I ordered may not work to check the ABS system, looks like most of them out there don't either.