RobertA
New Member
- Joined
- November 13, 2008
- Messages
- 7
- Reaction score
- 1
- City, State
- Orlando, FL
- Year, Model & Trim Level
- 1999 Explorer Eddie Bauer
Thanks to the info on this site, I was able to diagnose my issue with the heat stuck on except when the AC is on max, along with the clicking noise (Faulty blend door actuator). So I replaced my blend door actuator, but now it looks like the actuator is not getting power, because when I adjust the temp. the actuator does not move.
I checked the fuse for the blend motor actuator in the fuse box and it is OK. I know that the blend door is not stuck or broken, because I can move it. I pulled the actuator back out and kept the wires / connector connected to the actuator, then I adjusted the temp range on my automatic temp control (ATC) and found that the blend door actuator does not move at all, leaving me thinking that it no longer is getting power / commands. I also connected my old actuator (the one with the broken teeth on the gears) and this one no longer moves either, when I adjust the temp on my ATC. Any help from you folks would be appreciated, because I am pulling out my hair on this one. thanks Robert
I checked the fuse for the blend motor actuator in the fuse box and it is OK. I know that the blend door is not stuck or broken, because I can move it. I pulled the actuator back out and kept the wires / connector connected to the actuator, then I adjusted the temp range on my automatic temp control (ATC) and found that the blend door actuator does not move at all, leaving me thinking that it no longer is getting power / commands. I also connected my old actuator (the one with the broken teeth on the gears) and this one no longer moves either, when I adjust the temp on my ATC. Any help from you folks would be appreciated, because I am pulling out my hair on this one. thanks Robert