G
geoph1986
I went to my local U-Pull yesterday to get some stuff, and while there I decided to get a better flowing MAF housing. However, it seems that they are a hot item around here and I couldn't find one on a 4.6L or a 5.0L. So I got one out of a 3.8L Windstar, and it seems that it will fit/bolt in just fine. It looks the same as pics of the 5.0L one, and has a 75mm diameter at it's narrowest point. Now my question...Is the sensor in the Windstar housing the same as my X? They look the same (different part numbers, but I think it's because they are sold as a unit, sensor+housing) and the filaments on the Windstar one are in far better cosmetic condition than the one on the X. I'd prefer to clean and use the sensor off the Windstar, if I could.