No crank no start

[Ksaville1976]

I have a 92 mazda Navajo 4.0 liter was driven went to store then had to have it towed home. Batter is fully charged replace the selinoid side wall still nothing

 

[joney]

Welcome to the forum!

Check out the 1st gen forum - your model of Navajo is in there.

Stock 1991 - 1994 Explorers

For questions related to the base Ford Explorer. Problem solving, maintenance, TSB, service bulletins, owner reviews, specifications. No modification questions.

www.explorerforum.com

 

[410Fortune]

if you turn the key to on and the dash comes on?
Can you hear the fuel pump prime?
then you turn to start and nothing happens?

First test is to wiggle/test the battery cable/connections
second test is to put truck in RUN, make sure it is NOT IN GEAR, then jumper the starter solenoid on the inner fender with a screwdriver

does the starter turn?

 

[Fix4Dirt]

I have a 92 mazda Navajo 4.0 liter was driven went to store then had to have it towed home. Batter is fully charged replace the selinoid side wall still nothing

does it crank?

 

[Josh P]

does it crank?

Maybe the thread should be renamed.

 

[Fix4Dirt]

Maybe the thread should be renamed.

million dollar question!!

"you just gotta punch, then crank back 3 times form left to right"

 

[Josh P]

Killing me smalls! The OP needs to provide more information for the issue to be narrowed down.

 

[Fix4Dirt]

Killing me smalls! The OP needs to provide more information for the issue to be narrowed down.

its the only song i could think of with crank in the lyrics!

 

[Ksaville1976]

if you turn the key to on and the dash comes on?
Can you hear the fuel pump prime?
then you turn to start and nothing happens?

First test is to wiggle/test the battery cable/connections
second test is to put truck in RUN, make sure it is NOT IN GEAR, then jumper the starter solenoid on the inner fender with a screwdriver

does the starter turn?

I've replace the starter solenoid on the inner fender just hear a clunk when I turn the key ,I've tried to jump the solenoid and nothing happens

 

[Josh P]

I've replace the starter solenoid on the inner fender just hear a clunk when I turn the key ,I've tried to jump the solenoid and nothing happens

Do you have a breaker bar and a socket to fit the crankshaft bolt? Put the transmission in neutral and turn the engine over a little bit with the bar then try to start it. I've had starters get bad spots where nothing would happen until it was moved from that spot, then it would start like nothing was wrong.

 

[Josh P]

I've also had the wire from the solenoid to the starter go bad.