JetPlayer
New Member
- Joined
- July 15, 2008
- Messages
- 2
- Reaction score
- 0
- City, State
- CA
- Year, Model & Trim Level
- '98 Eddie Bauer
Hi I am new to the forum. I confirmed that the blend door is not broken and moves freely, I purchased a new actuator motor from Napa. I plugged in the new motor and turned on the EATC, the motor post that goes into the blend door did not move. I adjusted the temp up and down and no movement.
Is there a way to reset the whole EATC module and get the new motor to operate properly?
I have run the diagnostic on the EATC and I get a 024 and 025 code.
Any thoughts would be greatly appreciated. Thanks
Is there a way to reset the whole EATC module and get the new motor to operate properly?
I have run the diagnostic on the EATC and I get a 024 and 025 code.
Any thoughts would be greatly appreciated. Thanks