The oil in the intake was getting to me
We had to take off the supercharger to change its oil 8 bolts and some vac lines
So while it was off we decided to modify the factory oil separator
The oil separator is baffled but tons of oil gets through still
We added some surface area lol
Now the metal was unrolled and very carefully put it up in the separator between the baffles very fluffy like
We put it in there in a way so that it CANT get blown or sucked out put 150 psi through it both ways ...no little pieces or shavings in there
There's also no resistance in the flow through it
Pcv valve operates normally
The picture below shows it halfway in there
The zip tie was temporary
We did install a new o ring
We didn't use all of it just some....about 6"
I just put a fresh one for the picture
It works lots more surface area for the oil vaper droplets to stick to and drip back down
I'm sure their is some risk but
Yall know i would not risk my motor
seriously its strong Cooper And in there good
I will clean this In my ultra sonic cleaner every 50k when I change the supercharger oil no prob
I also installed a small separator on the intake end to
A small amount of oil was getting blown out of the valve cover vent under boost ....before this mod
I will update