Sway-bar endlink problem | Ford Explorer Forums

  • Register Today It's free!

Sway-bar endlink problem

04xplorer

Member
Joined
February 28, 2011
Messages
12
Reaction score
0
City, State
michigan
Year, Model & Trim Level
04 xlt
Hello, i was just looking over my ex today and had noticed both sway-bar endlink bolts had broken clean off and you could freely move the sway bar around. I have not done any serious wheeling but i did install some btf spacers & a set of 265s back in may 2011. I have had to of been driving around for at least a 1000 miles with it like this. Has anyone had this problem?? Thanks!!
 






Iv'e had them brake off, and it is common. You might not notice it is gone until you try an emergency maneuver, such as a sudden lane change. You will notice excessive vehicle body roll, and possible loss of control which can lead to catastrophe.
 






Thanks for the quick reply. I will get a new set soon, so do you think it would be a good idea to remove my sway bar when i go to the dunes to prevent them from breaking?
 






Yes on the removal, if you visit dunes often there are quick disconnect kits on the market. It will also give you more suspension travel when removed which is a plus on any trail. Just keep the speeds low and avoid the above mentioned maneuvers and you will be fine. Don't forget the rears.
 






Featured Content

Back
Top