transfer case shift motor plug wires

[Bapster]

Hi All, I have a question about the wiring pins for the transfer case shift motor. There are 2 light green wires and 2 gray w/red wires and I was wondering if someone could tell me which of those wires goes into which pin? For example if pin 3 (light green wire) is for the front speed sensor or the rear? Same with pin 8 (gray wire with red stripe)? I added in a page where I found the wiring diagrams...hope I'm allowed to do that?...as I can't figure out how to just post an image....Thanks guys and I appreciate all your help. The reason I am asking this is I may have mixed up these wires when I replaced the shift motor, so I seem to have 4x4 hi in reverse only, not when going forward....even my 4auto isn't working now :/
The diagram is near the bottom of this url ---> http://rsgear.com/articles/2001_05.pdf