Photos Show your 1st gen flex photos

[Nedwreck]

No biggie.

was actually trying to figger out what all that thing was made of.

 

[CliffRonning]

 

[blueka]

Here's some... just shackles and tyres so far....

It needs more tho....

Si

 

[yostyexplorer94]

Yosty's Flex

That's me checking for anything out of place while flexed

 

[zjrog]

I'm not sure which is worse... Same spot for both the EX and the Ranger.

EX is bone stock, except for 31s.

The Ranger has Skyjacker 6" coils and they are STIFF! I don't know how much disconnecting the swaybar would have done. Ranger is also on 31s in these pics.

But the Ranger is going SAS and long arms and 33s... So it ought to flex better than this...

Yes, I was stuck. Incline was worse than it looked and I couldn't get the drivers rear wheel out of the gulley. And only the front swaybar was disconnected.

 

[jordan1948]

Delete

 

[Jzop]

After new 33" pro comp X terrains and SOA/3inBL

 

[F150hybred]

OK... I'm in... this is my 94 Explorer.

6" lift in front... SOA in rear on 33's. I'm still kinda new at this and it's my first attempt.

 

[bgh1441]

2 inch lift on 31's, swaybars connected
Not pushed to full potential still

 

[Shen2187]

Guess I need to hit the RTI ramp again and take the camera this time.

 

[FROADER]

bgh1441 - I found this kind of funny. Your truck is exactly what mine started out as.

Before:

After:

 

[bgh1441]

i wish mine was up to that level

 

[deathbypsi]

Some fresh shots.

 

[Shen2187]

Is that a... Dana 30 under there? Nevermind, I read your sig lol. I'm going to use a Dana 44 when I do my swap.

 

[bgh1441]

what kind of bumper is that.

 

[Kona]

Updated flex shot

Here we are on the ramp with the 5 1/2" lift and 33's

 

[Desert Rat]

what kind of bumper is that.

I fabbed that bumper up when I was in high school, its all cut and welded, didn't have access to a bender at the time....it hasnt failed me yet though

 

[bgh1441]

what did u do for brackets cause im about to make one

 

[Desert Rat]

what did u do for brackets cause im about to make one

I cut out four 1/4 inch plates, 2 of them slightly shorter. Drilled the holes and mounted them to the framerails. Notched the ends with a grinder to fit the main tube and just built up from there. Tacked pieces together, then removed to fully weld.

 

[Shen2187]

Completely stock stuffing 33x12.5/15 on stock 15x7 ranger wheels.
Front Sway-Bar removed, Rear still hooked up. It's actually hitting bump stop and not the wheel well...

It refuses to resize the last image for somereason, my apologies.
Scratch that... it finally did.