Search results

I have a friend that just purchased a 1999 Ford Explorer 5.0 V8 with the intensions of removing the motor and installing it in his Wrangler. If he unhooks the automatic transmission from the 5.0 will the computer still let the engine run normal or will it put it in a "limp home" mode? He plans...

Im going to finish my clutch install tonight when my help gets here. Right now I have all the lines, plugs, driveshafts and crossmember bolts undone. Just to make sure...how many bolts do I have to remove to pull the tranny away from the block...its a 1992 2.3L 5-speed? Thanks.

I have a 1992 Ford Ranger with a 4cyl, 5-speed manual and electronic 4x4. Im getting ready to remove the tranny to install a new clutch and slave cylinder. Can I drop the transmission without removing/draining the transfer case? If I can do this...do I have to drain the tanny? I have done...

My 1992 Ford Ranger 4x4 4cyl 5-spd has a clutch issue. I have had a small leak in my clutch system which requires me to refill it every 3-4 months. Today after about a 120 mile trip, I pulled up to a stop light and noticed there was no clutch pedal pressure when I pushed it...and the truck...

I managed to break my timing cover in half on my 1992 Ford Ranger 2.3L. Should I fix this or just leave it off? Thanks.

I have a 1992 Ford Ranger 4x4 that I leveled using the Daystar bushings on the front coils. Im about to order tires next week. What is the largest size I can fit on my truck? Sorry don't have time to search....at work! Later.

I have a 1992 Ford Ranger 4x4. About 2-3 weeks ago I had new brakes installed all the way around and a new sensor put in the pumpkin. This didn't take away my "rear anitlock" light...but we have determined that its the ABS valve which I don't plan on replacing (its just a work truck). Now...

I have been trying to figure out my "rear anitlock" light for about a month now. I have replaced the rear brakes and the sensor in the axle. People have told me it was my RABS valve on the frame rail. Is there any way to fix this other than just replace it? The reason I ask is because its a...

I have a 1992 Ford Ranger 4x4 4cyl 5spd. When I first start the truck up and turn the air on it seems to be getting cold, but a couple minutes down the road it stops getting cool for just about 30 seconds. Then it acts normal (ice cold) for the rest of the trip. Is this normal? Thanks.

I have a 1992 Ford Ranger 4cyl. 5-speed 4x4. I took it to the shop today and they replaced the brakes all the way around. Before I took it in, the "rear antilock" light was on. It was still on after my brakes were changed and the mechanic said I needed a new sensor. Well I replace the sensor...

My parents have a 1996 Explorer. When they turn the passenger side turn signal on they get a buzzing sound and the turn signal does not flash...any ideas would be great. Thanks.

I have a 1996 Ford Explorer and just installed a class III hitch today. I purchased a Hoppy plug in 4-pin harness (no splicing required). Where is the trailer wiring located so I can plug this in? Thanks for any help.

I purchased a 1992 Ford Ranger and the tailgate won't open when you pull the handle. How do you fix this? Right now I have to use a screwdriver to open it. Thanks.

If your shift motor on your transfer case is acting up will it keep your push button 4x4 lights from coming on? My truck won't go into 4x4 and I have no lights. Thanks.

I have a 1992 Ranger 4x4 with push-button 4x4 and Warn manual lock hubs. I know I have to lock the hubs in, but when I hit the button on the dash nothing happens...no lights or anything. Any suggestions welcome. Thanks.

I just bought a 1991 Ford Ranger 4x4 and I want to level it out in the next couple of weeks. I believe I can level it by just getting a set of coil spring spacers for the front from Daystar. Please let me know if this is correct. Also, with these spacers...will I need new shocks? Thanks.

My brother called me at 1 AM this morning becuase he was sitting on the side of the road. He was driving and all of a sudden the truck (1993 Ford Ranger 2.3 4cyl. auto) died. I went to look at it....it cranked like it wanted to start, but it wouldn't. Everything electrical works and I even...

I have a 1992 Ford Explorer (170,000 miles) and it just died on me. I went to see my grandmother and when I came out the truck wouldn't start (a couple days before the truck cranked over so slowly I didnt think it was going to start). What I know: -battery is less than a year old -original...

I have had trouble with my A/C system before, so this is no surprise. My A/C compressor locked up and I want to just bypass it....can I leave everything in place and just install a belt for an Explorer without A/C? Thanks.

Here is my new toy: Let me know what you think. Later.

Hey....Im wanting to take the X up a little higher since I am due for a new set of tires. I already have a shackle/spacer lift and am wanting to do a 2" or 3" body lift....Im wanting to see some pictures first of body lifts installed on 1st gens before I order the lift...I have a hitch and Im...

Im going to order a set of rims from 4wheelparts and if I order them by midnight I get free shipping and 10% off. I need to know... is 5 on 4.5 the same as 5-4.5mm also what is the stock backspacing? Thanks.

Here is my truck (4" lift this fall) and atv (big bore this spring). They both have a ways to go, but I still have fun with them! http://www.sounddomain.com/memberpage/242328/1

My Explorer seems to be taking forever to heat up (inside) and even after 30 minutes doesnt seem to get very warm inside the truck. (6 degree weather too!) What could be causing this? Thermostat? Heater Core? How hard are these to replace? Thanks for any suggestions. :)

I just purchased a B&M Shift+ Transmission Kit for my '92 Explorer. It was like $42 and they said I only have to hook up two vacum hoses to install it. Im getting the Explorer back tomorrow with a newly rebuilt transmission in it! Is this B&M kit safe to use on it...what are the pros and cons...